Accessories - Dumpster Bins
Dumpster Bins
Dumpster Bins

Installation Kit Includes:

  • 1 - Bin c/w hinged door and latch for unloading.
  • 1 - Lid c/w 4 collars for attaching to your existing connectors.
  • 4 - Chains for holding lid in open position when removing bin.
  • 4 - 3" x 3" x 1/4" angle iron legs designed to bolt to existing stubs, thus providing additional necessary clearance for entry and removal of bin.
  • Bolts and nuts required for conversion.

Are you tired of emptying 45 gallon drums to dispose of your waste ??

Convert your N. R. Murphy Limited 4 drum storage model MKA or MKAW negative pressure dust collector to our new 26 cubic foot Dumpster Bin.

The Dumpster Bin is designed to fit under all standard 4 drum MKA series models and can be handled with most smaller fork lifts.

Note: On all 50" x 60" (length x width) models, the bin installation and removal is via a 60" side only.

Emptying is as easy as lifting the lid, removing the bin with your fork lift and depositing the waste into a receptacle using the hinged door c/w latch on the bottom of the bin.

Dumpster Bins
Dumpster Bins

Conversion Prodecure:

  1. Remove existing drums.
  2. Remove drum lids from connector sleeves (retain clamps).
  3. Support the dust collector on one side while you remove two of the existing support legs.
  4. Attach two new angle iron legs with 3/8" bolts, nuts and lock washers provided.
    (Note: Two additional 7/16" dia. holes must be drilled in the existing leg stubs to complete this operation.
  5. Drill and lag the legs to the floor.
  6. Repeat steps 3 - 5 for the other two legs.
  7. Centre the bin under the dust collector and mark the location of each corner on the bottom of the dust collector.
  8. Remove the bin.
  9. Drill a 7/16" dia. hole at each mark.
  10. Attach one length of chain (hook end down) with nuts and bolts provided, ensuring an air tight seal.
  11. Place the lid on the bin and place under the dust collector.
  12. Connect the drum connector sleeves to the bin lid with the clamps removed in step 2.
WebSite Design
by Galganov
N.R. Murphy Ltd